1. Remove the rear headrests.
2. Remove the headrest inserts by prying the latch on the right side of the inside of the sleeve while popping it out with a screwdriver in the notch in the front of the sleeve. Fig. 1 shows the notch and latch.
[[file:9009-3Rearseat-1.jpg|thumb|none|Fig. 1 - Headrest insert showing notch and latch]]
3. Remove the two screws holding the handle of the latch in place.
4. Pry up the piece of plastic that covers the right side of the cross bar.
6. Remove the cable from one side of the latch cable carrier.
7. Modify nylon washer so that it doesn't take up too much slack and thread onto cable.
[[file:9009-3Rearseat-2.jpg|thumb|none|Fig. 2 - Modified washer]][[file:9009-3Rearseat-3.jpg|thumb|none|Fig. 3 - Washer, cable and cable cover]]
8. Put cable back into carrier.
9. Reattach cable to lever on right side.
10. Put crossbar cover back in place.
11. Put screws back into handle.