# Remove the rear headrests.
# Remove the headrest inserts by prying the latch on the right side of the inside of the sleeve while popping it out with a screwdriver in the notch in the front of the sleeve. Fig. 1 shows the notch and latch.
[[file:9009-3Rearseat-1.jpg|thumb|none|Fig. 1 - Headrest insert showing notch and latch]]
# Remove the two screws holding the handle of the latch in place.
# Pry up the piece of plastic that covers the right side of the cross bar.
# Remove the cable from one side of the latch cable carrier.
# Modify nylon washer so that it doesn't take up too much slack and thread onto cable.
[[file:9009-3Rearseat-2.jpg|thumb|none|Fig. 2 - Modified washer]][[file:9009-3Rearseat-3.jpg|thumb|none|Fig. 3 - Washer, cable and cable cover]]
# Put cable back into carrier.
# Reattach cable to lever on right side.
# Put crossbar cover back in place.
# Put screws back into handle.